Bb-electronics MAP450D Manuel d'utilisateur télécharger pdf (Page 8)

6. Connect the OIT operating cable wires to the terminal block. Refer to

sections 2.1 through 2.3 and Figure 4.

7. Pull out any slack from the OIT operating cable.

8. Rotate the rear of the OIT enclosure back into position while gently pulling

out the new slack generated in the cable as you proceed.

CAUTION: Due to the large size of the ferrite coil, it must be positioned very

carefully. Make sure that when the OIT enclosure halves are brought together, the

ferrite coil is positioned so there is no internal interference. The ferrite coil must be

positioned up against the inside wall of the OIT enclosure with the protruding OIT

operating cable kept short.

9. Tighten the cable strain relief nut.

10. Re-install the four screws into the back of the OIT enclosure

11. Route the operating cable to the host controller and connect.

12. Route the power pigtail to the OIT power supply.

13. Install the wires into the power supply as follows:

RED +output

BLACK -output

SHIELD case ground.

8 MAP450D

1010-0046A, REV 00

RS485

RS232

POWER

TB1

RXD

RTS

CTS

TXD

RXD-

TXD-

RTN

TXD+

RXD+

COM

+24V

Heatshrink tubing

Chassis shield wire

Ferrite coil

Connection to

communication

wires of

Host/Controller

+24V

Function

Pin #

COM

RXD+

RXD- 5

TXD+

TXD-

RTN

RXD

TXD

CTS

RTS

Figure 4 Terminal Block Pinout Connection

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Bb-electronics MAP450D Manuel d'utilisateur Page 8

Commentaires sur ces manuels