Bb-electronics MAP450D Manuel d'utilisateur télécharger pdf (Page 16)

The OIT is connected to the mounting plate with four #6-32UNC screws. The

length of the mounting screws is equal to the plate thickness plus 1/4 inch.

NOTE: The mounting screws must not be torqued to more than 18 pound-inches.

Over-torquing can strip the threads in the enclosure.

3.3. Benchtop Mount

The MAP450D’s rear cover has two legs set at a five degree angle to give the display

and keypad a sloped front while sitting on a bench. Four rubber feet are attached to

the legs to prevent slippage as well as damage to the surface of the bench.

16 MAP450D

1010-0046A, REV 00

0.156 dia. nominal,

MOUNTING

PLATE

5.400 +/-0.015

5.00 nominal

4.600 +/-0.015

6.00 nominal

4 holes(clearance

(1/8" thick min. recommended)

for #6 screws)

PEDESTAL

2 places

Figure 11 Pedestal/Pendant Mounting Plate Dimensions

Figure 12 MAP450D Benchtop Mounting

1 2 ... 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Bb-electronics MAP450D Manuel d'utilisateur Page 16